Kurzweil Flash Play PC4 - Common Parameters for Track Functions; From and to; Events

Song Mode
The TRACK Page
8-24
Common Parameters for Track Functions
Locate
is parameter is available for every function on the TRACK page. It appears at the lower
left hand corner of the page.
e Locate bar, beat, and tick will change in real time during playback and recording to
reect the song’s current position. It can be set to any bar, beat, and tick. Playback begins at
this position, and Stop resets the song to this position.
From and To
From and To are available in most TRACK edit functions to dene a range of time on
the selected track(s). e From value denes the rst bar, beat, and tick in a range of time
selected for editing. e To value denes the nal bar, beat, and tick in a range of time
selected for editing.
Events
Use the Events parameter to select the type of MIDI event to edit. Available Event types are:
All, Notes, Velocity, Controllers, MonoPress, PitchBend, ProgChange, PolyPress. Some event
types are available only for certain Functions.
When Events is set to All, all MIDI events on the track(s) you are editing that occur in the
region of time between the From and To settings will be aected by the edit function.
When Events is set to Notes, note number and velocity ranges can be set for Note events.
(Some Functions may not provide velocity range parameters).
When Events is set to Velocity, the velocity range can be set for Note events.
When Events is set to Controllers, the Controller and Value Range can be set for Controller
events.
Key Range
e left and right Key Range elds respectively determine the lowest and highest notes in a
range of notes that will be aected by the selected Track Function.
Velocity Range
e left and right Velocity Range elds respectively determine the lowest and highest
velocities in a range of velocities that will be aected by the selected Track Function.
Controller
e Controller parameter selects the Controller (or All Controllers) to be aected.