2MV
1-2-19
* : Not used in this model.
▲: One piece is used in this model.
Procedure
1. Press the power key on the operation
panel to off. Make sure that the power
indicator and the memory indicator are
off before turning off the main power
switch. And then unplug the power
cable from the wall outlet.
2. Fit the key counter socket assembly to
the key counter retainer using two
screws and nut.
Note: Take out the wire from the central
portion of the key counter retainer, as
shown in a figure.
3. Fit the key counter mount to the key
counter cover using two screws.
4. Fit the key counter retainer to the key
counter mount using two screws.
Figure 1-2-23
M3 nut
1 7BC1003055++H01
M3 x 8 bronze binding screw
1* B1B03080
M4 x 30 tap-tight S screw
1* B1B54300
M4 x 6 chrome TP screw
5 B4A04060
M4 x 10 chrome TP screw
2 B4A04100
Parts Quantity Part.No.
M3 x 6 flat-head screw
Key counter
mount
Key counter cover
M4 x 6 screw
Key counter socket assembly
M3 nut
Key counter
retainer
M4 x 6 screw
M4 x 6 screw
M4 x 6 screw
To Next Page
Loading...
