Kyocera TASKalfa 2550ci - Page 44

2MV
1-2-20
1. Remove two screws of the DP interface
connector and then remove the DP
interface connector.
2. Remove the DP.
3. Remove seven screws.
4. Pull the rear cover upwards and then
release three hooks.
5. Remove the rear cover.
Figure 1-2-24
6. Remove two screws and then remove
the ISU right cover.
7. Remove the right upper cover.
Figure 1-2-25
Screw
Screw
Screw
Screw
Rear cover
Hooks
Hook
DP interface
connector
Screws
Screw
Screw
Screws
Right upper
cover
Screw
ISU right cover