2MV-8
2-3-18
YC20
1 EJE_SOL_RE
TURN
O 0/24 V DC FSSOL: On/Off
Connected to
shift sole-
noid, eject
motor, paper
full sensor,
job paper full
sensor, job
eject paper
sensor
2 24V4 O 24 V DC 24 V DC power output to FSSOL
3 EJECT_/B O 0/24 V DC (pluse) EM drive control signal
4 EJECT_/A O 0/24 V DC (pluse) EM drive control signal
5 EJECT_B O 0/24 V DC (pluse) EM drive control signal
6 EJECT_A O 0/24 V DC (pluse) EM drive control signal
7 3.3V4 O 3.3 V DC 3.3 V DC power output to PFS
8 GND - - GROUND
9 EJE_FULL_U
P
I 0/3.3 V DC PFS: On/Off
10 3.3V4 O 3.3 V DC 3.3 V DC power output to JEPS
11 GND - - GROUND
12 EJE_FULL_D
WN
I 0/3.3 V DC JEPS: On/Off
YC21
1 24V4 O 24 V DC 24 V DC power output to C/IHCFM
Connected to
container / IH
coil fan
motor, devel-
oper fan
motor and
eject fan
motor
2 IH_FAN2_RE
M
O 0/24 V DC C/IHCFM: On/Off
3 IH_FAN2_AL
M
I 0/3.3 V DC C/IHCFM alarm signal
4 24VIL O 24 V DC 24 V DC power output to DEVFM
5 DLP_FAN_RE
M
O 0/24 V DC DEVFM: On/Off
6 24V4 O 24 V DC 24 V DC power output to EFM
7CON_FAN_R
EM
O 0/24 V DC EFM: On/Off
YC22
1 FUSREMA O 0/24 V DC PRM: On/Off
Connected to
thermistor1,
thermistor2,
eject sensor,
fuser press
release
motor
2 FUSREMB O 24 V DC 24 V DC power output to PRM
3 3.3V4 O 3.3 V DC 3.3 V DC power output to ES
4 GND - - GROUND
5 FUSER_JAM I 0/3.3 V DC ES: On/Off
6 3.3V4 - - Not used
7GND - - Not used
8 FUSER_PRE - - Not used
9 SUBSDA I/O 3.3 V DC Data
10 SUBSCL O 3.3 V DC Clock
11 PR_TH I Analog FTH detection voltage (Press roller)
12 HR_NCTH1 I Analog FTH detection voltage (Center)
13 HR_NCTH2 I Analog FTH detection voltage (Center)
Connector Pin Signal I/O Voltage Description
To Next Page
Loading...
