LEGRAND PDU - Page 329

June 2018
Legrand PDU User Guide 329
If the content is successfully entered, the CLI displays this message "Successfully entered Restricted
Service Agreement" followed by the total number of entered characters in parentheses.
Note: The new content of Restricted Service Agreement is saved only after typing the apply command. See
Quitting Configuration Mode (on page 293).
Example
The following example illustrates how to specify the content of the Restricted Service Agreement.
1. Type the following command and press Enter to start entering the content.
config:# security restrictedServiceAgreement bannerContent
2. Type the following content when the CLI prompts you to enter the content.
IMPORTANT!! You are accessing a PDU. If you are not the system administrator, do
NOT power off or power cycle any outlet without the permission of the system
administrator.
3. Press Enter.
4. Type the following:
--END--
5. Press Enter again.
6. Verify that the message "Successfully entered Restricted Service Agreement" is displayed, indicating
that the content input is successful.
Login Limitation
The login limitation feature controls login-related limitations, such as password aging, simultaneous logins
using the same user name, and the idle time permitted before forcing a user to log out.
A login limitation command begins with security loginLimits.
You can combine multiple commands to modify various login limitation parameters at a time. See
Multi-Command Syntax (on page 381).
Single Login Limitation
This command enables or disables the single login feature, which controls whether multiple logins using the
same login name simultaneously is permitted.
config:# security loginLimits singleLogin <option>
Variables:
 <option> is one of the options: enable or disable.
Option Description
enable Enables the single login feature.
disable Disables the single login feature.