LEGRAND PDU - Page 361

June 2018
Legrand PDU User Guide 361
Parameters Description
bindDN <bind_DN>
Change the bind DN.
 <bind_DN> is the new bind DN.
bindPassword
Change the bind DN password.
a. First add the "bindPassword" parameter to the command,
and press Enter.
b. The system prompts you for the input of the password.
c. Type the password and press Enter.
sortPosition <position>
Change the priority of the server (that is, resorting).
 <position> is the new sequential number of the server in
the LDAP server list.
Note: For details of the above variables' values, see Adding an LDAP Server (on page 356).
 Examples:
 Change the IP address of the 1st LDAP server
config:# authentication ldap modify 1 host 192.168.3.3
 Change both the IP address and TCP port of the 1st LDAP server
config:# authentication ldap modify 1 host 192.168.3.3 port 633
 Change the IP address, TCP port and the type of the L1st DAP server
config:# authentication ldap modify 1 host 192.168.3.3 port 633
serverType activeDirectory
Removing an Existing LDAP Server
This command removes an existing LDAP server from the server list.
config:# authentication ldap delete <server_num>
Variables:
 <server_num> is the sequential number of the specified server in the LDAP server list.
Radius Settings
All Radius-related commands begin with authentication radius.
If you enable Radius authentication, you must add at least one Radius server. Later you can modify or delete
any existing Radius server as needed.
Adding a Radius Server
You can repeat the following commands to add Radius servers one by one.
 Command syntax: