Chapter 5
| VLAN Configuration
IEEE 802.1Q VLANs
– 142 –
Configuring VLAN
Groups
Use the VLAN > Static (Add) page to create or remove VLAN groups, set
administrative status, or specify Remote VLAN type (see “Configuring Remote Port
Mirroring” on page 130). To propagate information about VLAN groups used on
this switch to external network devices, you must specify a VLAN ID for each of
these groups.
Parameters
These parameters are displayed:
Add
◆
VLAN ID – ID of VLAN or range of VLANs (1-4094).
VLAN 1 is the default untagged VLAN.
◆
Status – Enables or disables the specified VLAN.
◆
Remote VLAN – Reserves this VLAN for RSPAN (see “Configuring Remote Port
Mirroring” on page 130).
Modify
◆
VLAN ID – ID of configured VLAN (1-4094).
◆
VLAN Name – Name of the VLAN (1 to 32 characters).
◆
Status – Enables or disables the specified VLAN.
Show
◆
VLAN ID – ID of configured VLAN.
◆
VLAN Name – Name of the VLAN.
◆
Status – Operational status of configured VLAN.
◆
Remote VLAN – Shows if RSPAN is enabled on this VLAN (see “Configuring
Remote Port Mirroring” on page 130).
Web Interface
To create VLAN groups:
1.
Click VLAN, Static.
2.
Select Add from the Action list.
3.
Enter a VLAN ID or range of IDs.
4.
Check Status to configure the VLAN as operational.
5.
Specify whether the VLANs are to be used for remote port mirroring.
To Next Page
Loading...
