Chapter 4
| Interface Configuration
Port Configuration
– 98 –
Figure 32: Configuring Connections by Port List
Configuring by
Port Range
Use the Interface > Port > General (Configure by Port Range) page to enable/
disable an interface, set auto-negotiation and the interface capabilities to
advertise, or manually fix the speed, duplex mode, and flow control.
Parameters
Except for the trap command, refer to “Configuring by Port List” on page 96 for
more information on command usage and a description of the parameters.
Web Interface
To configure port connection parameters:
1.
Click Interface, Port, General.
2.
Select Configure by Port Range from the Action List.
3.
Enter a range of ports to which your configuration changes apply.
4.
Modify the required interface settings.
5.
Click Apply.
To Next Page
Loading...
