Chapter 13
| Basic Administration Protocols
LBD Configuration
– 392 –
Configuring Interface
Settings for LBD
Use the Administration > LBD (Configure Interface) page to enable loopback
detection on an interface, to display the loopback operational state, and the VLANs
which are looped back.
Parameters
These parameters are displayed:
◆
Interface – Displays a list of ports or trunks.
■
Port – Port Identifier. (Range: 1-10/28)
■
Trunk – Trunk Identifier. (Range: 1-8)
◆
Admin State – Manually enables or disables an interface. (Default: Enabled)
◆
Operation State – Valid states include Normal or Looped.
◆
Looped VLAN – Shows the VLANs which are in looped state.
Web Interface
To configure interface settings for LBD:
1.
Click Administration, LBD, Configure Interface.
2.
Make the required configuration changes.
3.
Click Apply.
Figure 257: Configuring Interface Settings for LBD
To Next Page