LevelOne GEL-1061 - Binding a Port to an Access Control List; Figure 176: Configuring a ARP ACL

Chapter 12 | Security Measures
Access Control Lists
– 277 –
Figure 176: Configuring a ARP ACL
Binding a Port to an
Access Control List
After configuring ACLs, use the Security > ACL (Configure Interface – Configure)
page to bind the ports that need to filter traffic to the appropriate ACLs.
Parameters
These parameters are displayed:
◆ Type – Selects the type of ACLs to bind to a port.
◆ Port – Port identifier. {Range: 1-10/28}
◆ ACL – ACL used for ingress packets.
◆ Time Range – Name of a time range.
◆ Counter – Enables counter for ACL statistics.
Web Interface
To bind an ACL to a port:
1. Click Security, ACL.
2. Select Configure Interface from the Step list.
3. Select Configure from the Action list.
4. Select IP, MAC or IPv6 from the Type options.
5. Select a port.