LevelOne GEL-1061 - Displaying Information for Dynamic Ipv4 Source Guard Bindings; Figure 197: Configuring Static Bindings for Ipv4 Source Guard; Figure 198: Configuring Static Bindings for Ipv4 Source Guard

Chapter 12 | Security Measures
IPv4 Source Guard
– 313 –
Figure 197: Configuring Static Bindings for IPv4 Source Guard
To display static bindings for IP Source Guard:
1. Click Security, IP Source Guard, Static Binding.
2. Select Configure ACL Table or Configure MAC Table from the Step list.
3. Select Show from the Action list.
Figure 198: Configuring Static Bindings for IPv4 Source Guard
Displaying
Information for
Dynamic IPv4 Source
Guard Bindings
Use the Security > IP Source Guard > Dynamic Binding page to display the source-
guard binding table for a selected interface.
Parameters
These parameters are displayed:
Query by
◆ Port – A port on this switch. (Range: 1-10/28)
◆ VLAN – ID of a configured VLAN (Range: 1-4094)
◆ MAC Address – A valid unicast MAC address.
◆ IP Address – A valid unicast IP address, including classful types A, B or C.