LevelOne GEL-1061 - Figure 252: Setting the Name of a Time Range; Figure 253: Showing a List of Time Ranges

Chapter 13 | Basic Administration Protocols
Setting a Time Range
– 388 –
Web Interface
To configure a time range:
1. Click Administration, Time Range.
2. Select Add from the Action list.
3. Enter the name of a time range.
4. Click Apply.
Figure 252: Setting the Name of a Time Range
To show a list of time ranges:
1. Click Administration, Time Range.
2. Select Show from the Action list.
Figure 253: Showing a List of Time Ranges
To configure a rule for a time range:
1. Click Administration, Time Range.
2. Select Add Rule from the Action list.
3. Select the name of time range from the drop-down list.
4. Select a mode option of Absolute or Periodic.
5. Fill in the required parameters for the selected mode.
6. Click Apply.