Figures
– 16 –
Figure 30: Restarting the Switch (At) 94
Figure 31: Restarting the Switch (Regularly) 94
Figure 32: Configuring Connections by Port List 98
Figure 33: Configuring Connections by Port Range 99
Figure 34: Displaying Port Information 100
Figure 35: Showing Port Statistics (Table) 103
Figure 36: Showing Port Statistics (Chart) 104
Figure 37: Configuring a History Sample 106
Figure 38: Showing Entries for History Sampling 106
Figure 39: Showing Status of Statistical History Sample 107
Figure 40: Showing Current Statistics for a History Sample 107
Figure 41: Showing Ingress Statistics for a History Sample 108
Figure 42: Displaying Transceiver Data 109
Figure 43: Configuring Transceiver Thresholds 111
Figure 44: Configuring Static Trunks 113
Figure 45: Creating Static Trunks 114
Figure 46: Adding Static Trunks Members 114
Figure 47: Configuring Connection Parameters for a Static Trunk 115
Figure 48: Showing Information for Static Trunks 115
Figure 49: Configuring Dynamic Trunks 115
Figure 50: Configuring the LACP Aggregator Admin Key 118
Figure 51: Enabling LACP on a Port 119
Figure 52: Configuring LACP Parameters on a Port 120
Figure 53: Showing Members of a Dynamic Trunk 120
Figure 54: Configuring Connection Settings for a Dynamic Trunk 121
Figure 55: Showing Connection Parameters for Dynamic Trunks 121
Figure 56: Displaying LACP Port Counters 122
Figure 57: Displaying LACP Port Internal Information 124
Figure 58: Displaying LACP Port Remote Information 125
Figure 59: Configuring Load Balancing 127
Figure 60: Enabling Power Savings 128
Figure 61: Configuring Local Port Mirroring 129
Figure 62: Configuring Local Port Mirroring 130
Figure 63: Displaying Local Port Mirror Sessions 130
Figure 64: Configuring Remote Port Mirroring 131
To Next Page