Chapter 13
| Basic Administration Protocols
Link Layer Discovery Protocol
– 338 –
■
ECS ELIN – Emergency Call Service Emergency Location Identification
Number supports traditional PSAP-based Emergency Call Service in North
America.
◆
Country Code – The two-letter ISO 3166 country code in capital ASCII letters.
(Example: DK, DE or US)
◆
What – The type of device to which the location applies as described for the
field entry “Device entry refers to” under “Configuring LLDP Interface
Attributes.”
Port Details – Extended Power-via-MDI
◆
Power Type – Power Sourcing Entity (PSE) or Power Device (PD).
◆
Power Priority – Shows power priority for a port. (Unknown, Low, High,
Critical)
◆
Power Source – Shows information based on the type of device:
■
PD – Unknown, PSE, Local, PSE and Local
■
PSE – Unknown, Primary Power Source, Backup Power Source - Power
conservation mode
◆
Power Value – The total power in watts required by a PD device from a PSE
device, or the total power a PSE device is capable of sourcing over a maximum
length cable based on its current configuration. This parameter supports a
maximum power required or available value of 102.3 Watts to allow for future
expansion. (Range: 0 - 102.3 Watts)
Port Details – Inventory
9
◆
Hardware Revision – The hardware revision of the end-point device.
◆
Software Revision – The software revision of the end-point device.
◆
Manufacture Name – The manufacturer of the end-point device
◆
Asset ID – The asset identifier of the end-point device. End-point devices are
typically assigned asset identifiers to facilitate inventory management and
assets tracking.
◆
Firmware Revision – The firmware revision of the end-point device.
◆
Serial Number – The serial number of the end-point device.
◆
Model Name – The model name of the end-point device.
To Next Page
Loading...
