110
Figure 39: Configuring Global and Port Settings for ARP Inspection
PARAMETERS
These parameters are displayed:
ARP Inspection Configuration
◆ Mode – Enables Dynamic ARP Inspection globally. (Default: Disabled)
Port Mode Configuration
◆ Port – Port identifier
◆ Mode – Enables Dynamic ARP Inspection on a given port. Only when both Global Mode
and Port Mode on a given port are enabled, will ARP Inspection be enabled on a given port.
(Default: Disabled)
WEB INTERFACE
To configure global and port settings for ARP Inspection:
1. Click Configuration, Security, Network, ARP Inspection, Configuration.
2. Enable ARP inspection globally, and on any ports where it is required.
3. Click Save.
Configuring Static Bindings for ARP Inspection
Use the Static ARP Inspection Table to bind a static address to a port. Table entries include a
To Next Page
Loading...
