LevelOne GEP-1070 - Page 151

151
Figure 60: MLD Snooping Port Group Filtering Configuration
PARAMETERS
These parameters are displayed:
◆ Port – Port identifier.
◆ Filtering Groups – Multicast groups that are denied on a port. When filter groups are
defined, MLD listener reports received on a port are checked against the these groups. If a
requested multicast group is denied, the MLD report is dropped.
WEB INTERFACE
To configure MLD Snooping Port Group Filtering:
1. Click Configuration, IPMC, MLD Snooping, Port Group Filtering.
2. Click Add New Filtering Group to display a new entry in the table.
3. Select the port to which the filter will be applied.
4. Enter the IP address of the multicast service to be filtered.
5. Click Save.