LevelOne GEP-1070 - Page 192

192
PARAMETERS
These parameters are displayed:
Displaying Port Tag Remarking Mode
◆ Port – Port identifier.
◆ Mode – Shows the tag remarking mode used by this port:
■ Classified – Uses classified PCP (Priority Code Point or User Priority) and DEI (Drop
Eligible Indicator) values.
■ Default – Uses default PCP/DEI values.
■ Mapped – Uses mapped versions of QoS class and drop precedence level.
Configuring Port Tag Remarking Mode
◆ Tag Remarking Mode – Configures the tag remarking mode used by this port:
■ Classified – Uses classified PCP/DEI values.
■ Default – Uses default PCP/DEI values. (Range: PCP – 0-7, Default: 0; DEI – 0-1,
Default: 0)
■ Mapped – Controls the mapping of the classified QoS class values and DP levels (drop
precedence) to (PCP/DEI) values.
■ QoS class/DP level – Shows the mapping options for QoS class values and DP levels
(drop precedence).
■ PCP – Remarks matching egress frames with the specified Priority Code Point (or User
Priority) value. (Range: 0-7; Default: 0)
■ DEI – Remarks matching egress frames with the specified Drop Eligible Indicator.
(Range: 0-1; Default: 0)
WEB INTERFACE
To show the QoS Egress Port Tag Remarking mode used for each port:
1. Click Configuration, QoS, Port Tag Remarking.
2. Click on any enter under the Port field to configure the Port Tag Remarking mode.
To configure the tag remarking mode:
1. Click Configuration, QoS, Port Tag Remarking.
2. Click on any of the entries in the Port field.
3. Set the tag remarking mode and any parameters associated with the selected mode.
4. Click Save.