36
Figure 4: IP Configuration
PARAMETERS
These parameters are displayed:
IP Configuration
◆ DHCP Client – Specifies whether IP functionality is enabled via Dynamic Host
Configuration Protocol (DHCP). If DHCP is enabled, IP will not function until a reply has
been received from the server. Requests will be broadcasted periodically by the switch for
an IP address. DHCP values can include the IP address, subnet mask, and default
gateway. (Default: Enabled)
◆ IP Address – Address of the VLAN specified in the VLAN ID field. This should be the
VLAN to which the management station is attached. Valid IP addresses consist of four
numbers, 0 to 255, separated by periods. (Default: 192.168.1.1)
◆ IP Mask – This mask identifies the host address bits used for routing to specific subnets.
(Default: 255.255.255.0)
◆ IP Router – IP address of the gateway router between the switch and management
stations that exist on other network segments.
◆ VLAN ID – ID of the configured VLAN. By default, all ports on the switch are members of
VLAN 1. However, the management station can be attached to a port belonging to any
VLAN, as long as that VLAN has been assigned an IP address. (Range: 1-4095; Default:
1)
◆ DNS Server – A Domain Name Server to which client requests for mapping host names to
IP addresses are forwarded.
To Next Page
Loading...
