LevelOne GEP-1070 - Page 96

96
◆ Rate Limiter – Shows if rate limiting will be enabled or disabled when matching frames
are found.
◆ Port Copy – Shows the port to which matching frames are copied.
◆ Mirror – Mirrors matching frames from this port. (Default: Disabled) See "Configuring Port
Mirroring" on page 198.
◆ Logging – Shows if logging of matching frames to the system log is enabled or disabled.
Open the System Log Information menu to view any entries stored in the system log for
this entry. Related entries will be displayed under the “Info” or “All” logging levels.
◆ Shutdown – Shows if a port is shut down when a macthing frame is found.
◆ Counter – Shows he number of frames which have matched any of the rules defined for
this ACL.
The following buttons are used to edit or move the ACL entry (ACE):
Table 9: QCE Modification Buttons
Button
Description
Inserts a new ACE before the current row.
Edits the ACE.
Moves the ACE up the list.
Moves the ACE down the list.
Deletes the ACE.
The lowest plus sign adds a new entry at the bottom of the list.
ACE CONFIGURATION
Ingress Port and Frame Type
◆ Ingress Port – Any port, port identifier, or policy. (Options: Any port, Port 1-10, Policy 1-8;
Default: Any)
◆ Frame Type – The type of frame to match. (Options: Any, Ethernet, ARP, IPv4; Default:
Any)
Filter Criteria Based on Selected Frame Type
◆ Ethernet:
MAC Parameters
■ SMAC Filter – The type of source MAC address. (Options: Any, Specific - user defined;
Default: Any)
■ DMAC Filter – The type of destination MAC address. (Options: Any, MC - multicast, BC -
broadcast, UC - unicast, Specific - user defined; Default: Any)