LevelOne GEP-1070 - Page 98

98
Ethernet (0x06) and the (PLN) is equal to IPv4 (0x04) must not match this entry, 1 -
ARP/RARP frames where the HLN is equal to Ethernet (0x06) and the (PLN) is equal to
IPv4 (0x04) must match this entry; Default: Any)
■ IP – Specifies whether frames can be matched according to their ARP/RARP hardware
address space (HRD) settings. (Options: Any any value is allowed, 0 - ARP/RARP frames
where the HRD is equal to Ethernet (1) must not match this entry, 1 -ARP/RARP frames
where the HRD is equal to Ethernet (1) must match this entry; Default: Any)
■ Ethernet – Specifies whether frames can be matched according to their ARP/RARP
protocol address space (PRO) settings. (Options: Any - any value is allowed, 0 -
ARP/RARP frames where the PRO is equal to IP (0x800) must not match this entry, 1 -
ARP/ RARP frames where the PRO is equal to IP (0x800) must match this entry; Default:
Any)
◆ IPv4:
MAC Parameters
■ DMAC Filter – The type of destination MAC address. (Options: Any, MC - multicast, BC -
broadcast, UC - unicast; Default: Any)
IP Parameters
■ IP Protocol Filter – Specifies the IP protocol to filter for this rule. (Options: Any, ICMP,
UDP, TCP, Other; Default: Any)
The following additional fields are displayed when these protocol filters are selected.
ICMP Parameters
■ ICMP Type Filter – Specifies the type of ICMP packet to filter for this rule. (Options: Any,
Specific: 0-255; Default: Any)
■ ICMP Code Filter – Specifies the ICMP code of an ICMP packet to filter for this rule.
(Options: Any, Specific (0-255); Default: Any)
UDP Parameters
■ Source Port Filter – Specifies the UDP source filter for this rule. (Options: Any, Specific
(0-65535), Range (0-65535); Default: Any)
■ Dest. Port Filter – Specifies the UDP destination filter for this rule. (Options: Any,
Specific (0-65535), Range (0-65535); Default: Any)
TCP Parameters
■ Source Port Filter – Specifies the TCP source filter for this rule. (Options: Any, Specific
(0-65535), Range (0-65535); Default: Any)
■ Dest. Port Filter – Specifies the TCP destination filter for this rule. (Options: Any,
Specific (0-65535), Range (0-65535); Default: Any)
■ TCP FIN – Specifies the TCP “No more data from sender” (FIN) value for this rule.
(Options: Any - any value is allowed, 0 - TCP frames where the FIN field is set must not
match this entry, 1 - TCP frames where the FIN field is set must match this entry; Default: