2-68 Service Manual
7526
200.11, 250.03—Paper Jam error service check
Step Questions / actions Yes No
1 Open the front access door. Turn the
transport belt gear clockwise.
Did the transport belt move?
Go to step 2. Replace the transport belt.
See “Transfer module
removal” on page 4-180.
2
Run align motor test with old pick assembly
installed in the machine.
1. Enter Diagnostics mode (press and hold
buttons 3 and 6, turn on the MFP, and
release the buttons when the progress bar
displays.
2. Touch MOTOR TESTS.
3. Touch Align Motor Test.
Can you hear the align motor run?
Go to “920.06—Input
sensor service check” on
page 2-114.
Go to step 3.
3
1. Plug in a new paper pick assembly into
the JFDPCK1 connector from outside the
machine.
2. Enter Diagnostics mode (press and hold
buttons 3 and 6, turn on the MFP, and
release the buttons when the progress bar
displays.
3. Touch MOTOR TESTS.
4. Touch Align Motor Test.
Can you hear the align motor run?
Replace the paper pick
mechanism. See “Paper
pick mechanism
assembly removal” on
page 4-130.
Replace the system board.
See “System board
removal” on page 4-157.
To Next Page
Loading...
