3-24 Service Manual
7526
Fuser temperature (Fuser Temp)
This adjustment can be used to help solve some customer problems with paper curl on low grade papers and
problems with letterheads on some types of media.
To adjust the fuser temperature:
1. Touch EP SETUP from the Diagnostics Menu.
2. Touch the left or right arrows beside Fuser Temp to toggle between Low, Normal, or High.
The default is Normal.
3. Touch Submit.
DC Charge Adjust, Dev Bias Adj, Transfer Adjust
Each of these three settings enables you to adjust the high voltage levels controlling the electrophotographic
process. You will use these settings to compensate for unusual operating circumstances such as high humidity.
The printer uses the value of these settings together with other settings to calculate printing speed and media
selection.
To adjust DC Charge Adjust:
1. Touch EP SETUP from the Diagnostics Menu.
2. Touch the left or right arrows beside DC Charge Adjust to toggle between Low, Normal, or High.
The default is Normal.
3. Touch Submit.
To Adjust Dev Bias Adj or Transfer Adjust:
1. Touch EP SETUP from the Diagnostics Menu.
2. Touch Adjust Dev Bias Adj or Transfer Adjust (these menu items work similarly).
Four choices appear:
Black
Magenta
Cyan
Yellow
3. Touch the left or right arrows beside the setting or settings you want to change.
Select Low, Normal, or High. The default is Normal.
4. Touch Submit.
Reports
Menu Settings Page
The Menu Settings Page is a list of Diag Menu settings with the current value.
To print the Menu Settings Page:
1. Touch REPORTS from the Diagnostics Menu.
2. Touch Menu Settings Page.
The following displays and the page or pages print.
Printing...
Menu Settings Page
Touch Back to return to the Diagnostics Menu.
To Next Page
Loading...
