4-104 Service Manual
7526
Fuser assembly removal
See “Fuser assembly, 115 V”, “Fuser assembly, 230 V”, or “Fuser assembly, 100 V” on page 7-5 for the
part number.
1. Turn off the printer.
2. Open the top access door.
3. Open the front access door.
4. Rotate the fuser thumbscrews (A) counterclockwise until loosened.
5. Grasp the handles (B), slide the fuser out from the printer.
Installation note: If you install a new fuser, be sure to reset the fuser counter in the Configuration Menu. To
reset the counter:
1. Turn off the multifunction printer, press and hold buttons 2 and 6, turn on the MFP, and release the buttons
when the progress bar displays.
2. Touch Reset Fuser Cnt from the Configuration Menu.
3. Touch Yes or No.
4. Select Exit Config Menu.
See “Reset Fuser Count” on page 3-30.
CAUTION—HOT SURFACE:
The inside of the printer might be hot. To reduce the risk of injury from a hot component, allow
the surface to cool before touching.
To Next Page
Loading...
