Diagnostic aids 3-15
7526
Duplex Tests
Quick Test (duplex)
Note: Before you set the duplex top margin, be sure to set the skew and alignment. See “Printhead
alignment” on page 4-10.
This test prints a duplex version of the Quick Test that can be used to verify the correct placement of the top
margin on the back side of a duplex page.
You can run one duplexed page (Single), or continue printing duplexed pages (Continuous) until is
pressed. For information about changing the margin, see “Top Margin (duplex)” on page 3-17.
The paper you choose to print the page on should be either Letter or A4.
To print the Quick Test (duplex):
1. Touch DUPLEX TESTS.
2. Touch Quick Test.
3. Select Single or Continuous.
• The single Duplex Quick test cannot be canceled. It stops when a single duplex sheet is printed.
• The continuous test continues printing until you press .
• The printer attempts to print the Quick Test Page from the default paper source.
• Check the Quick Test Page for the correct offset between the placement of the first scan line on the
front and back side of a duplexed sheet.
To Next Page
Loading...
