3-34 Service Manual
7526
To restore Factory Defaults:
1. Print Menu Settings from the Administration Menu, the Diagnostic Menu, and the Configuration Menu.
If you need to reset customer settings you have a record.
2. Touch Factory Defaults from the Configuration Menu.
3. Touch Restore Base, Restore STD NET, or Restore LES. The Restore Network value only appears on
printer models that have integrated network support.
Restoring Factory Defaults… appears on the operator panel while factory defaults are restored.
Resetting the Device... appears and the MFP performs a POR.
After a POR, the printer starts in the Home state.
Energy Conserve
This menu item affects the values that appear in the Power Saver menu on the operator panel. Energy
Conserve only appears when the Power Saver feature is disabled.
Select Off in Energy Conserve to add a menu item to the Power Saver called Disabled. Energy Conserve does
not disable Power Saver, it only allows the users to select Disable. When On (default) is selected in the Energy
Conserve menu Disabled does not appear on as a choice in the Power Saver menu. Power Saver cannot be
disabled from the user‘s operator menu.
To change the Energy Conserve setting:
1. Touch Energy Conserve from the Configuration Menu.
2. Touch the or arrow to toggle between On and Off.
3. Touch Submit.
Submitting changes… is displayed.
You are automatically returned to the Configuration menu.
Fax Low Power Support
The values for this setting include Auto (default), Permit Sleep, and Disable Sleep.
The Auto value relies on the firmware’s logic to determine if the device supports the fax portion of the low power
architecture. Permit Sleep allows the fax chip to enter low power mode (regardless of the value of Caller ID
Pattern) whenever the device determines that it should. Disable Sleep prohibits the fax chip from ever entering
low power mode.
NumPad Job Assist
This setting determines whether or not a user can configure and initiate a job using the operator panel buttons.
When this is set to On, a user can choose a function, such as copy, fax, or so forth, and then enter specific
values for a limited number of settings and initiate the job with a series of key presses. When turned to Off, the
feature is not available.
To change the Numpad Job Assist value:
1. Touch NumPad Job Assist from the Configuration Menu.
2. Touch the or arrow to toggle between On and Off.
3. Touch Submit.
Submitting changes… is displayed.
You are automatically returned to the Configuration menu.
Min Copy Memory
To Next Page
Loading...
