4-4 Service Manual
7526
Screw and retainer identification table
The following table contains screw types and retainers, locations, and quantities necessary to service the
printer. Pay careful attention to each screw type location when doing removals. You must install the correct
screw type in each location during reassembly.
Sizes are as close to actual as possible, as long as the printout is not scaled or resized.
Screw identification table
P/N Screw type Location Qty
077-0601-0 Plastite M3x6, black CCD cover 2
CCD Lamp 2
CCD Lamp cover 2
Rear cover 6
077-0819-0 Plastite washer
M3x8
CCD belt to flatbed 1
077-0824-0 Plastite M4x8 Upper housing 6
077-1408-0 Plastite M4x14 Hinges to ADF 4
10B1580 #6 Panhead Cooling fan to top cover 2
To Next Page
Loading...
