Diagnostic aids 3-11
7526
Print Tests
Input source tests
The purpose of the diagnostic Print Tests is to verify that the printer can print on media from each of the installed
input options. The contents of the Print Test Page varies depending on the media installed in the selected input
source.
Check each Test Page from each source to assist in print quality and paper feed problems.
To run the Print Test Page:
1. Touch PRINT TESTS from the Diagnostics Menu.
2. Select the media source by touching the green arrow next to one of the items below:
Tray 1
Tray 2 (if installed)
Tray 3 (if installed)
Tray 4 (if installed)
Tray 5 (if installed)
Multi-Purpose Feeder (if installed)
Print Quality Pages
Only installed trays will appear on the display.
3. Select either Single or Continuous.
• If Single is selected, a single page is printed.
• If Continuous is selected, printing continues until is pressed to cancel the test.
If a source is selected that contains envelopes, an envelope test pattern is printed. If Continuous is
selected, the test pattern is printed only on the first envelope.
Note: The Print Test Page always prints on one side of the paper, regardless of the duplex setting.
To Next Page
Loading...
