4-260 Service Manual
7526
9. Remove the card.
Scanner ICC cable removal
1. Remove the ADF. See “ADF removal (entire)”
2. Turn the ADF over. Be sure to brace the ADF to prevent damage.
3. Remove the three screws (A) securing the MDC cable cover, and remove the cover.
4. Disconnect the ICC cable (B) from the scanner ICC card.
5. Remove the screw (C) securing the cable tie-down, and remove the cable from the tie-down.
6. Remove the cable from the cable restraints (D), and note the routing.
7. Open the clips (E) on the toroid, and set it aside for reinstallation later.
To Next Page
Loading...
