3-42 Service Manual
7526
To encrypt a disk:
1. Touch Disk Encryption from the Configuration Menu.
2. Touch Enable to encrypt the disk.
3. Touch Yes.
Warning: To prevent damage to your disk, do not turn the MFP off while the following displays.
4. Touch Back to return to the main menu.
A graphic appears, showing:
• The message Encrypting Disk or Formatting Disk
• A percentage scale
• The message DO NOT POWER OFF
The process is complete when the percentage scale displays 100.
Wipe Disk
Note: Due to the lengthy amount of time required to wipe an entire hard disk using either method, a wipe should
not be initiated unless it is absolutely unavoidable (for example, disk corruption), or unless the printer can
remain offline for several hours without inconveniencing users.
Warning: A user should not initiate either type of wipe from the Configuration Menu if the hard disk contains
downloaded fonts, macros, held jobs, and so forth that should not be erased.
This setting initiates either a single pass wipe or a multiple pass wipe of the entire hard disk. Select Disk Wipe
(fast) to complete a single pass wipe and replacement of the file system. Select Disk Wipe (secure) to
complete a multiple pass wipe at a more basic level.
Encrypting Disk
5/7 30%
DO NOT
POWER OFF
To Next Page
Loading...
