3-18 Service Manual
7526
6. Perform Quick Test again to verify the adjustment. Check the page to see if the image on the page is still
skewed. If it is, repeat the adjustment.
Sensor Tests
There are two groups of sensors tests, static sensors and dynamic sensors.
To run the Sensor Test:
1. Touch SENSOR TESTS from the Diagnostics Menu.
2. Select either Static Sensors or Dynamic Sensors.
• For static sensors—view the current status. Exit menus and enter the menus again to change the
state.
• For dynamic sensors—view the current status and toggle the state to test the sensor.
Press to exit a test.
Sensor type Sensor name Possible values Sensor activation
Static sensors
Waste Toner Empty, Full, or
Missing
N/A
Belt Waste Empty or
percentage full
N/A
Fuser Temp Degrees (C) N/A
BUR Temp Degrees (C) N/A
Power Voltage N/A
To Next Page
Loading...
