Lexmark X746de - ADF Input Sensor Service Check

Diagnostic information 2-139
7526
Go Back
Previous
Next
ADF input sensor service check
2
Remove the ADF motor side cover. See
“ADF motor side cover removal” on
page 4-212.
Is the ADF exit sensor cable (A) connected
correctly?
Go to step 3. Reseat the cable in
connector.
3
Replace the ADF exit sensor. See “ADF exit
sensor (with cable) removal” on
page 4-234.
Did the error clear?
Problem resolved. Contact the next level of
support.
Step Questions / actions Yes No
1 1. Turn the printer off.
2. Open the ADF front cover.
Is the flag (A) damaged?
Replace the ADF case
assembly. See “ADF case
assembly removal” on
page 4-230.
Go to step 2.
Step Questions / actions Yes No