4-130 Service Manual
7526
Paper pick mechanism assembly removal
See “Paper pick assembly” on page 7-5 for the part number.
1. Remove the paper tray.
2. Remove the waste toner assembly. See “Waste toner assembly removal”.
3. Remove the rear frame cover. See “Rear frame cover removal” on page 4-37.
4. Disconnect the connector in JFDPCK1 (A) and JTRAY1 (B) on the system board.
5. Open the latch (C) to remove the toroids from the cables.
6. Push the cables through the hole in the frame below the two connectors.
To Next Page
Loading...
