4-230 Service Manual
7526
Installation note: Make sure to attach the ground cable to the screw (see step 5 from previous page).
Warning: Whenever you replace the ADF (entire), the flatbed scanner, or the MDC card, perform the “Scanner
Manual Registration” in Configuration menu.
To enter Config Menu:
1. Turn off the multifunction printer.
2. Press and hold buttons 2 and 6.
3. Turn on the MFP.
4. Release the buttons when the progress bar displays.
ADF case assembly removal
1. Remove the ADF front cover. See “ADF front cover removal” on page 4-208.
2. Disconnect the sensor cable (A).
To Next Page
Loading...
