2-12 Service Manual
7526
34 Short Paper • Touch Continue to clear the message and continue printing.
Note: The printer does not automatically reprint the page that prompted the message.
• Check the tray length and width guides to ensure the media is properly fitted.
• Make sure the print job is requesting the correct size of media.
• Adjust the Paper Size setting for the media size being used.
• If the MP Feeder Size is set to Universal, make sure the media is large enough for the
formatted data.
• Cancel the current job. Replace the paper pick mechanism. See “Paper pick
mechanism assembly removal” on page 4-130.
• If the problem still exists, replace the system board. See “System board removal” on
page 4-157.
35 Insufficient memory
to support Resource
Save feature
•Touch Continue to disable Resource Save and continue printing.
• To enable Resource Save after receiving this message:
- Make sure the link buffers are set to Auto, then exit the menus to activate the link
buffer changes.
- When Ready is displayed, enable Resource Save.
• Install additional memory.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-157.
37 Insufficient memory
to collate job
•Touch Continue to print the portion of the job already stored and begin collating the rest
of the job.
• Cancel the current job.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-157.
37 Insufficient memory
for Flash Memory
Defragment operation
•Touch Continue to stop the defragment operation and continue printing.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
• If this does not fix the problem, replace the system. See “System board removal” on
page 4-157.
37 Insufficient memory,
Some Held Jobs Were
Not Restored
• The printer deleted some held jobs in order to process current jobs.
•Touch Continue to clear the message.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-157.
37 Insufficient memory,
Some Held Jobs Will
Not Be Restored
• The printer was unable to restore some or all of the confidential or held jobs on the hard
disk.
•Touch Continue to clear the message.
• If this message occurs again, replace the hard drive.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-157.
37 Insufficient Defrag
Memory
New
There is insufficient memory to perform the Flash Memory Defragment operation. The user
can:
• Delete font, macros, and other data in memory.
• Install additional printer memory.
38 Memory Full The following options are available:
•Touch Continue to clear the message and continue printing. The job may not print
correctly.
• Cancel the current job.
• Install additional printer memory.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-157.
Error code Action
To Next Page
Loading...
