Diagnostic information 2-37
7526
292.00 Scanner ADF cover open jam.
Possible causes:
• ADF cover sensor flag
• ADF cover sensor
• ADF improper grounding of the
feed shaft to skew shaft or feed
shaft to ADF upper cover
• Remove all media present in the media path.
• Check ADF left door interlock sensor for proper
operation. Go to “292.00—Scanner ADF cover
open jam service check” on page 2-100.
293.00 Paper missing. • Remove all media present in the media path.
• Check the ADF input sensor for proper
operation. Go to “ADF input sensor service
check” on page 2-139.
293.02 Flatbed cover open. • Remove all media present in the media path.
• Check the ADF closed interlock switch for
proper operation. Go to “293.02—Flatbed
cover open jam service check” on
page 2-104.
296 Scanner flatbed CCD carrier module
locked in home position.
Unlock the scanner flatbed CCD carrier module lock
(scanner lock).
8xx service error messages
840.01
Scanner Error
Scanner disabled Enable the Scanner:
1. Enter the Configuration Menu (press and hold 2
and 6, turn on the MFP, and release the buttons
when the progress bar displays).
2. Touch Disable Scanner in the Config Menu.
3. Touch the left or right arrows to select Enabled
(default), Disabled, or ADF Disabled.
4. Touch Submit.
Submitting changes… is displayed.
840.02
Scanner Error
Scanner auto disabled Print out the error log and see what caused the MFP
to disable
Go to the Configuration Menu and enable the
scanner:
1. Enter the Configuration Menu (press and hold 2
and 6, turn on the MFP, and release the buttons
when the progress bar displays).
2. Touch Disable Scanner in the Config Menu.
3. Touch the left or right arrows to select Enabled
(default), Disabled, or ADF Disabled.
4. Touch Submit.
Submitting changes… is displayed.
Error code Description Action
To Next Page
Loading...
