Lexmark XM3150 - Page 104

Stapler carriage jam service check
Action Yes No
Step 1
Open the stapler service cover. Reseat the sensor (stapler throat)
cable. Then reseat also the other end of the cable on the controller
card, and then POR the machine.
Does the error remain?
Replace the stapler
accumulator
assembly. See
“Stapler
accumulator
assembly removal”
on page 422.
POR the machine. If
the error persists,
then go to step 2.
The problem is
solved.
Step 2
Open the stapler right cover. Reseat the stapler carriage assembly
cables. Then reseat also the other end of the cables on the
controller card, and then POR the machine.
Does the error remain?
Go to step 3. The problem is
solved.
Step 3
Enter Diagnostic mode and navigate to:
FINISHER TESTS > Staple Test
Does the error remain?
Replace the stapler
carriage assembly.
See
“Stapler
carriage assembly
removal” on
page 387.
POR the machine. If
the error persists,
then go to step 4.
The problem is
solved.
Step 4
Check the stapler interface cable. If damaged, then replace the
cable. See
“Stapler interface cable removal” on page 403.
Reseat the interface cable on the controller card, and then POR
the machine.
Does the error remain?
Go to step 5. The problem is
solved.
Step 5
Reseat all connectors on the controller card, and then POR the
machine.
Does the error remain?
Replace the stapler
controller card. See
“Stapler controller
card removal” on
page 397.
The problem is
solved.
7016
Diagnostic information
104