4 Route the cable through the flatbed assembly, and remove it from the flatbed assembly.
USB cable removal
1 Remove the right cover. See “Right cover removal” on page 277.
2 Remove the controller board shield. See “Controller board shield removal” on page 284.
3 Remove the fan.
4 Disconnect the MFP wireless cable from the RIP board.
5 Remove the scanner front cover. See “Scanner front cover removal” on page 361.
6 Remove the control panel assembly. See “Control panel assembly removal” on page 298.
7 Remove the UICC drip pan.
8 Remove the USB cable bracket. See “USB cable bracket removal” on page 304.
7016
Repair information
369
To Next Page
Loading...
