Lexmark XM3150 - 241 Paper Jams

241 paper jams
241 paper jam messages
Error code Description Action
241.01 Paper over tray 1 pass thru sensor on warmup. Go to
“Tray 1 jam service check” on page 84.
241.02 Sensor (input) early arriving jam.
241.03 Tray 1 pass thru sensor never became covered
when feeding a sheet from an option below.
241.06 Failed to pick from tray 1. Exhausted all pick retries.
Paper present sensing indicated media is in the
tray.
241.07 Option tray 1 pass thru sensor never became
uncovered when feeding a sheet from an option
below.
241.13 The media is late reaching the sensor (input)
within the specified time from tray 1.
241.14 The media is late reaching the sensor (input)
within the specified time from tray 1.
241.15 Media tray 1, tray pulled jam.
241.16 The engine timed out waiting for the tray 1 to
report 'ready' before the 1st pick attempt.
241.17 Page was not properly picked from tray 1. Have not
exhausted all pick retry attempts as there are
sheets committed to the paper path from below.
241.18 Failed to feed from tray 1. Exhausted all pick
retries. Paper present sensing indicates media is
in the tray.
241.20 Took too long to ramp up media feeder motor in
tray 1.
Go to
“Tray 1 jam service check” on page 84.
241.21 Media feeder motor stall in tray 1.
241.22 Media feeder motor pick motor underspeed in tray
1.
241.24 Media feeder motor stalled on the last pick
attempt in tray 1.
241.29 Tray 1 lift plate failed to make the index sensor
while elevating.
241.32 Media tray not ready.
241.33 The media tray was pulled during the media pick
process.
7016
Diagnostic information
83