Lexmark XM3150 - Page 84

Error code Description Action
241.41 Media feeder motor stall in tray 1. Go to
“Tray 1 jam service check” on page 84.
241.42 Media feeder motor pick motor under‑speed in
tray 1.
241.43 Media feeder motor stalled on the last pick
attempt in tray 1.
241.44 Motor 2 (Separator/Passthru) motor stalled.
241.45 Motor 2 (Separator/Passthru) motor PWM
overflow error (underspeed). Motor underspeed
(max PWM and motor underspeed, typical
accordion jam).
241.46 Motor 2 (Separator/Passthru) motor ramp (end
ramp - did not reach speed, typical pack feed
paper jam).
241.47 Motor 3 motor stalled.
241.48 Motor 3 motor PWM overflow error (underspeed).
Motor underspeed (max PWM and motor
underspeed, typical accordion jam).
241.49 Motor 3 motor ramp (end ramp - did not reach
speed, typical pack feed paper jam).
Tray 1 jam service check
Action Yes No
Step 1
Restart the printer.
Does it fail to complete the POST sequence and display a 241.xx
error?
Replace the index
sensor.
Go to step 2.
Step 2
Check the pick tires.
Are they free of wear or damage?
Go to step 3. Replace the pick
tires.
Step 3
Check the separator roll assembly.
Is it free of wear or damage?
Go to step 4. Replace the
separator roll
assembly. See
“Separator roll
assembly removal”
on page 376.
Step 4
Check the tray guides and lift plate gear.
Are they free of wear or damage?
Go to step 5. Replace the tray
insert.
7016
Diagnostic information
84