Lexmark XM3150 - Media Present Sensor Flag Removal

6 Remove the duplex. See “Duplex removal” on page 324.
7 Position the printer so that it sits on its left side.
8 Disconnect the cable JACM1 from the controller board.
9 Release the retainer spring (A) from the bracket (B).
10 Remove the screw (C).
A C
B
Media present sensor
flag
removal
1 Remove the left cover. See “Left cover removal” on page 264.
2 Remove the rear door and cover. See “Rear exit door removal” on page 342 and “Rear cover removal”
on page 343.
3 Remove the power supply. See “Power supply removal” on page 323.
4 Remove the power supply shield. See “Power supply shield removal” on page 323.
5 Remove the duplex. See “Duplex removal” on page 324.
6 Position the printer so that it sits on its left side.
7 Remove the retainer spring (A).
8 Remove the two springs (B).
7016
Repair information
332