Index sensor removal
1 Remove the left cover. See “Left cover removal” on page 264.
2 Remove the right cover. See “Right cover removal” on page 277.
3 Remove the rear door and cover. See “Rear exit door removal” on page 342 and “Rear cover removal”
on page 343.
4 Remove the power supply. See “Power supply removal” on page 323.
5 Remove the power supply shield. See “Power supply shield removal” on page 323.
6 Remove the duplex. See “Duplex removal” on page 324.
7 Disconnect the cable JINDEX1 from the controller board.
8 Remove the screw (A).
9 Route o the cable, and then remove the index sensor.
Media present sensor removal
1 Remove the left cover. See “Left cover removal” on page 264.
2 Remove the rear door and cover. See “Rear exit door removal” on page 342 and “Rear cover removal”
on page 343.
3 Remove the power supply. See “Power supply removal” on page 323.
4 Remove the power supply shield. See “Power supply shield removal” on page 323.
7016
Repair information
328
To Next Page
Loading...
