Lexmark XM3150 - Flatbed Assembly Removal; Control Panel Ribbon Cable Removal; Speaker Cable Removal

Flatbed assembly removal
1 Remove the ADF assembly. See “ADF unit removal” on page 362.
2 Remove the scanner assembly from the MFP. See “Scanner assembly removal” on page 365.
3 Remove the control panel assembly. See “Control panel assembly removal” on page 298.
4 Remove the ADF cable. See “ADF cable removal” on page 368.
5 Remove the USB wireless cable. See “USB wireless cable removal” on page 370.
6 Remove the control panel USB cable. See “USB cable removal” on page 369.
7 Remove the speaker cable. See “Speaker cable removal” on page 372.
8 Remove the wireless control panel cover.
Installation note: After the new
flatbed
is installed, perform scanner manual registration, see
“Scanner
manual registration” on page 227 and scanner calibration, see “Scanner calibration” on page 203.
Control panel ribbon cable removal
1 Remove the left cover. See “Left cover removal” on page 264.
2 Remove the scanner front cover. See “Scanner front cover removal” on page 361.
3 Remove the control panel assembly. See “Control panel assembly removal” on page 298.
4 Lift the control panel assembly, disconnect the ribbon cable (JUICC1) from the UICC card, and then feed the
ribbon cable through the wire channel.
Speaker cable removal
1 Remove the left cover. See “Left cover removal” on page 264.
2 Remove the controller board shield. See “Controller board shield removal” on page 284.
7016
Repair information
372