8 If necessary, remove the bushing (B) from the redrive assembly.
Installation note: Install the bushing (A) on the redrive assembly before installing the shaft.
Fuser removal
1 Remove the left cover. See “Left cover removal” on page 264.
2 Remove the rear door and cover. See “Rear exit door removal” on page 342 and “Rear cover removal”
on page 343.
3 Remove the redrive assembly. See “Redrive assembly removal” on page 343.
4 Disconnect the cable JEXIT1 from the controller board.
5 Disconnect the two cables (A).
7016
Repair information
346
To Next Page
Loading...
