Stapler cooling fan removal
1 Remove the stapler right cover. See “Stapler right cover removal” on page 384.
2 Remove the stapler left cover. See “Stapler left cover removal” on page 385.
3 Remove the stapler rear cover. See “Stapler rear cover removal” on page 393.
4 Remove the stapler service cover. See “Stapler service cover removal” on page 397.
5 Disconnect the cooling fan cable CN8 from the controller card.
6 Remove the four screws (A) from the cooling fan.
7 Route the cable o the stapler, and remove the cooling fan.
Note: Pay attention to the original routing of the cable.
Stapler power supply unit removal
1 Remove the stapler right cover. See “Stapler right cover removal” on page 384.
2 Remove the stapler left cover. See “Stapler left cover removal” on page 385.
3 Remove the stapler rear cover. See “Stapler rear cover removal” on page 393.
4 Remove the stapler cooling fan. See “Stapler cooling fan removal” on page 401.
5 Remove the stapler service cover.
6 Disconnect the power supply cable CN5 from the controller card.
7016
Repair information
401
To Next Page
Loading...
