Lexmark XM3150 - Trailing Edge Sensor Removal

8 Remove the two screws (B).
9 Disconnect the cable from the sensor.
Installation notes:
a Apply the RheoGel 739 to the top and bottom of the shutter blade extension.
b Apply the RheoGel 739 to the point of contact between the bracket (A) and cam.
c Apply the RheoGel 739 to the lower edge (B) where the wiper bracket glides.
Trailing edge sensor removal
1 Remove the left cover. See “Left cover removal” on page 264.
2 Remove the right cover. See “Right cover removal” on page 277.
3 Remove the rear door and cover. See “Rear exit door removal” on page 342 and “Rear cover removal”
on page 343.
4 Remove the power supply. See “Power supply removal” on page 323.
5 Remove the power supply shield. See “Power supply shield removal” on page 323.
7016
Repair information
331