Top Margin -16 to +16 Increasing the value moves the image down the page. Always adjust
the top before the bottom margin.
Bottom Margin -20 to +20 Increasing the value moves the image toward the top of the page.
Left Margin ‑25 to +25 Increasing the value moves the image toward the right margin. Always
adjust the left before the right margin.
Right Margin -30 to +30 Use this to adjust the printhead.
Note: The alignment of the left margin positions the black plane to the right or left. The alignment of the
right margin does not alter the margins and should only be used to adjust the printhead.
Scanner calibration
This test calibrates the black and white values for the ADF and flatbed. Use the following values to manually
adjust a replacement scanner.
Menu items Values
Flatbed Black ‑10 to 10*
ADF Front Black ‑10 to 10*
ADF Back Black ‑10 to 10*
Flatbed White ‑10 to 10*
ADF Front White ‑10 to 10*
ADF Back White ‑10 to 10*
* The default value is 0.
To adjust a calibration value, do the following steps:
1 Navigate to Diagnostics Menu > Scanner Calibration.
2 Select a calibration value to adjust.
3 To view the result for an ADF front adjustment, place a test page image side up and touch Copy Quick
Test. Compare the results to the original. Adjust if necessary.
4 To view the result for an ADF back adjustment, place a test page image side down and touch Copy Quick
Test. Compare the results to the original. Adjust if necessary.
5 To view the result for a flatbed adjustment, do the following:
a Remove any paper from the ADF. Compare the results to the original. Adjust as needed.
b Place a test page on the flatbed and touch Copy Quick Test.
c Compare the results to the original. Adjust if necessary.
Reset
flatbed,
ADF front, and ADF back calibration values
These settings revert the selected scan source IQT black and white values back to the Nominal Black and
Nominal White settings.
Perform this test only on a replacement scanner.
7016
Service menus
203
To Next Page
Loading...
