Lexmark XM3150 - Tamper Drive Belt Removal

12 Remove the four screws (B), and then remove the sub-assembly.
Tamper drive belt removal
1 Remove the stapler right cover. See “Stapler right cover removal” on page 384.
2 Remove the stapler left cover. See “Stapler left cover removal” on page 385.
3 Remove the stapler rear cover. See “Stapler rear cover removal” on page 393.
4 Remove the stapler service cover. See “Stapler service cover removal” on page 397.
5 Remove the stapler controller card. See “Stapler controller card removal” on page 397.
6 Remove the stapler cooling fan. See “Stapler cooling fan removal” on page 401.
7 Remove the stapler power supply unit. See “Stapler power supply unit removal” on page 401.
8 Remove the stapler top cover. See “Stapler top cover removal” on page 405.
9 Remove the tamper main assembly. See “Tamper main assembly removal” on page 415.
10 Remove the tamper sub-assembly. See “Tamper sub-assembly removal” on page 416.
11 Remove the tamper motors. See “Stapler left tamper motor removal” on page 397 and “Stapler right
tamper motor removal” on page 398.
7016
Repair information
418