Error code Description Action
903 Busy tone detected. Check with remote end if successive
attempts fail.
904 Hardware error detected. See
“Modem/fax card service check”
on page 170.
905 A timeout occurred after dialing the
number and waiting for a response.
Check with remote end if successive
attempts fail.
906 Fax cancelled by user. No action needed.
907 Modem detected a digital line connection. Verify the MFP is connected to an analog
line. See
“Fax transmission service
check” on page 173.
908 Phone line was disconnected Restore phone line connection.
A00 Received request for unsupported
function from remote fax device.
No action needed.
A01 Received request for unsupported image
width from remote fax device.
No action needed.
A02 Received request for unsupported image
resolution from remote fax device.
No action needed.
A03 Received request for unsupported
compression type from remote fax device.
No action needed.
A04 Received request for unsupported image
length from remote fax device.
No action needed.
F00 Unknown error occurred. No action needed.
Escalating a fax issue to second‑level support
Before contacting the second-level support, go to the SE menu on the MFP, and then generate a Fax error file.
This file contains printer settings information and debug information that will help second-level support
determine the cause of a failure.
To generate the fax error
file,
perform the following steps:
1 In a Web browser, type http://MFP/<IP address>/se.
2 The MFP’s SE menu page will display. Click the “Dump Job History” link. The following displays:
3 Write down the type of connection, the type of error, and the job in which the error occurred.
7016
Diagnostic information
179
To Next Page
Loading...
