Lexmark XM3150 - 202 Paper Jams

202 paper jams
202 paper jam messages
Error code Description Action
202.01 Exit sensor is covered during warm up. Go to
“Sensor (fuser exit) jam service check” on
page 81.
202.03 Media did not reach the fuser exit sensor. Go to
“Sensor (fuser exit) jam service check” on
page 81.
202.05 Fuser exit sensor covered too long by the current
sheet.
Go to
“Sensor (fuser exit) jam service check” on
page 81.
202.07 Fuser exit sensor covered too long by the
previous sheet.
Go to
“Sensor (fuser exit) jam service check” on
page 81.
202.13 Restart attempted after an internal jam without
cover open. Close event. Likely that the jam was
not actually cleared.
Go to
“Sensor (fuser exit) jam service check” on
page 81.
202.14 Expected banner sheet ( assumed wide ) not
detected by narrow media sensor, possible
accordion jam, unsupported narrow banner
media, or missing signal.
Go to
“Sensor (fuser exit) jam service check” on
page 81.
202.16 Page at fuser nip before fuser started ramping
toward desired. Indicates code may be receiving
more hall interrupts than intended.
Go to
“Sensor (fuser exit) jam service check” on
page 81.
202.17 Page at fuser nip before fuser reached acceptable
operating temperature. Page arrived at fuser
earlier than expected, so it was probably staged.
Go to
“Sensor (fuser exit) jam service check” on
page 81.
202.22 Cartridge Motor - Motor Underspeed Error. Motor
made it to closed loop steady state, but then
detected speed was below threshold.
Go to
“Sensor (fuser exit) jam service check” on
page 81.
202.28 Exit sensor bounce issue. Go to
“Sensor (fuser exit) jam service check” on
page 81.
202.32 The sheet is too long to be duplexed. The blow
through is enabled.
Go to
“Duplex service check” on page 82.
202.36 Long paper or shingled multi feed stopped before
sending to duplex.
Go to
“Duplex service check” on page 82.
202.43 During warm up flush, media that passed the input
sensor failed to reach the exit sensor.
Go to
“Sensor (fuser exit) jam service check” on
page 81.
202.45 During warm up flush, sheet detected too long
over exit sensor.
Go to
“Sensor (fuser exit) jam service check” on
page 81.
7016
Diagnostic information
80