Lexmark XM3150 - Page 82

Error code Description Action
232.03 Input sensor never detected sheet from internal
duplex path.
Go to
“Duplex service check” on page 82.
232.10 Feed error picking from the duplexer. Go to
“Duplex service check” on page 82.
Duplex service check
Action Yes No
Step 1
a Remove the rear cover.
b Check the redrive rollers for wear or damage.
Are they free of wear or damage?
Go to step 2. Replace the redrive
assembly. See
“Redrive assembly
removal” on
page 343.
Step 2
a Remove the left cover. See “Left cover removal” on page
264.
b POR into the Diagnostics menu and navigate to:
DUPLEX TESTS > Duplex Feed 1
c Check the reverse solenoid for proper operation.
Does it function properly?
Go to step 3. Replace the reverse
solenoid. See
“Reverse solenoid
removal” on
page 273.
Step 3
a Remove the input tray.
b From under the printer, check the duplex gear assembly and
duplex link for wear and damage.
Are the they free of wear and damage?
Go to step 4. Replace the duplex
gear assembly. See
“Duplex gear
assembly removal”
on page 275.
Step 4
From under the printer, check the duplex, belt, and roller for wear
and damage.
Are they free of wear and damage?
Go to step 5. Replace the duplex.
See
“Duplex
removal” on
page 324.
Step 5
a POR into the Diagnostics menu and navigate to:
DUPLEX TESTS > Sensor Test
b Lower the jam access cover, and toggle the duplex sensor.
Does the sensor state on the control panel change when it is
toggled?
Go to step 6. Replace the duplex
sensor. See
“Duplex
sensor and input
sensor removal” on
page 325.
Step 6
Does the error remain?
Contact the next
level of support.
The problem is
solved.
7016
Diagnostic information
82